The UT system consists of the following
1) TRACER SLIDE 5) 2 AXIS ADJUSTING SLIDE
Heavy duty slide designed to operate This provides precise setup and accu-
at the full capacity of your machine. rate depth of cut adjustment. Zero
setting dials graduated .001 or .01mm.
2) MOUNTING ADAPTER 6) TRACER VALVE
Factory made for your machine. Valve responds equally to pressure
in 360 degrees. Helps with steep
opposed angles. Valve will deliver full
pump pressure to power side of piston.
3) ADJUSTABLE RETRACT STOP 7) TEMPLATE HOLDER
Limits tracer retraction-helpful in boring. Front mount units clamp to V-way.
This can save time in some cases. Rear mount units clamp to 36" dovetail
bar mounted to bed.
Standard template rail is 24" for flat
template. Other lengths and round
template holders available at extra cost.
4) PIVOTING VALVE ARM 8) HYDRAULIC POWER UNIT
Positions the tracer valve at the Consists of motor, pump, and reservoir.
template. Carefully designed to Sized to match system requirements.
dampen machine vibration Standard 120v, 1 phase, 60 mhz. Other
voltages available at extra cost.